Vyonix
Installation

No tools. No trim panels. Five minutes at most.

Find your product, read the steps, then check that everything is secure before driving. Contact us if your seat or wheel differs from the guide.

Vyonix beaded seat cover installed in a semi-truck cab driver seat
Under 5 min · 6 stepsBeaded seat cover, start to finishRead the installation guide →
Before you start✓Park level and slide the seat fully forward so you can reach behind the back.✓Empty the seat pockets and drop the armrests if they fold.✓Work in daylight or with the dome light on. No tools needed.✓Keep the bag — the hooks and discs are easy to miss in the packaging.
Vyonix beaded seat cover installed in a semi-truck cab driver seat
Open full guide →Shop beaded covers
Beaded seat cover

Hooks over the seat back, straps and discs behind, base pushed into the seam. No tools, and it cannot creep on a long shift.

  1. 1Slide the seat back and clear the headrest area.
  2. 2Hang the panel over the seat back with the top row above your shoulders.
  3. 3Hook the top clamps behind the seat and pull them down onto the frame.
  4. 4Run the straps behind the seat and clip the discs together.
  5. 5Lay the base section flat and push the edge into the seam.
  6. 6Sit in it once and re-tension. The beads should not slide when you shift.
Vyonix 18 inch steering wheel cover installed in a semi truck cab
Open full guide →Shop wheel covers
18" steering wheel cover

Seam at six o'clock, then stretch it up both sides with your thumbs. No tools, no lacing.

  1. 1Wipe the wheel down so the cover seats evenly.
  2. 2Line the cover seam up at the six o'clock position.
  3. 3Hook the bottom edge over the rim and hold it there.
  4. 4Work both thumbs up either side, stretching as you go.
  5. 5Roll the last section over the top of the rim.
  6. 6Run a hand right around to seat the inner layer flat.
Vyonix perforated suede car seat cushion with back and neck support, installed on a car driver seat
Open full guide →Shop cushions
Seat cushion

Contoured edge to the front, strap behind the seat back, neck pillow on the headrest.

  1. 1Take the old cushion out and clear anything off the seat pan.
  2. 2Set the cushion in with the contoured edge to the front.
  3. 3Run the strap behind the seat back and buckle it.
  4. 4Tension the strap so the cushion cannot walk forward.